Thu Jan 14, 2016 4:56 pm
#95756
Hi, I am trying to figure out which is the best bit to use with my router to clean up the shaved areas so I have one even consistent surface for the light to come through. I used a ball sphere bit to shave out the areas.
This is how it looked initially. As you can see, the light is not consistent in the shaved areas. That is what I want to fix.
I used another ball sphere bit that was a little bigger, but still not even.
Any recommendations will be appreciated.
Thanks,
Eric
This is how it looked initially. As you can see, the light is not consistent in the shaved areas. That is what I want to fix.
I used another ball sphere bit that was a little bigger, but still not even.
Any recommendations will be appreciated.
Thanks,
Eric